Just out todayAugmented reality: The AR trainees were faster on the model they trained on, and no better anywhere elseVirtual reality: They matched the exercise dose exactly, and the VR advantage fell below the line that mattersVirtual reality: Both groups used the same headset. One watched a video first and picked up 10.8 more blocks

Climate & energy tech/Algeria

Rainwater inside the panel cost 63.5 percent of its output, and took a year to build up

Rainwater getting inside the laminate cost a desert solar panel 63.5 percent of its daily output - the largest of three real-world losses measured.

What the paper found

Outdoor experiments on photovoltaic panels in the Ouargla region of southeast Algeria measured daily power loss from three real environmental factors, including some that take nearly a year to accumulate. Rainwater infiltration caused 63.5 percent daily power loss, real partial shading 27.6 percent and bird droppings 20.53 percent.

Grade 11 reading level6 min read

What happened

Solar panels are sold on an efficiency figure measured under standard test conditions in a laboratory. In a desert, what they actually produce depends on things the laboratory does not model: dust, shade, birds, and – as it turns out – water getting inside.

Researchers at the LENREZA Laboratory and the Department of Electronics and Telecommunication at the University of Ouargla, and the LMPMM-DMEERDA Laboratory at ENS of Ouargla, ran outdoor experiments on photovoltaic panels in the Ouargla region of southeast Algeria.

They measured three factors, and chose them partly because they take a long time to develop – nearing a year for rainwater infiltration and bird dropping accumulation.

Rainwater infiltration cost 63.5 percent of daily power output.

The test

The study’s stated novelty is twofold: investigating a combination of real environmental factors in a hot, arid desert region, and accounting for the formation period of factors that take a long time to accumulate.

That second point is the methodological contribution. Most soiling and degradation studies run for weeks and measure dust. A factor that needs nearly a year to build up is invisible to those studies regardless of how much damage it does.

The performance of a number of panels was evaluated under the influence of rainwater infiltration, real partial shading and bird droppings. Power output of each panel was then compared to determine the impact on energy conversion efficiency.

Using real partial shading rather than laboratory-simulated shading is the other sensible choice: field shading has a different geometry and therefore a different electrical effect.

The numbers

Factor Daily power loss Formation period
Rainwater infiltration 63.5% nearing a year
Real partial shading 27.6% immediate
Bird droppings 20.53% nearing a year
Market panel efficiency maximum about 22%
Location Ouargla region, southeast Algeria, hot arid desert

The last row is the context that makes the rest matter. A panel converts at most about 22 percent of the light that reaches it into electricity. Losing 63.5 percent of that is losing most of a small number.

The result

Daily power loss reached 63.5 percent for rainwater infiltration, 27.6 percent for real partial shading and 20.53 percent for bird droppings.

The authors frame the findings as providing insights for researchers to propose cost-effective solutions mitigating these factors.

The ranking is the interesting part, and it is not the ranking the field would predict. Shading is the loss mechanism that gets the engineering attention – bypass diodes, module-level power electronics, string design all exist to address it. Rainwater infiltration gets comparatively little, and here it cost more than twice as much.

How this compares to what came before

Desert photovoltaic performance research is dominated by soiling: dust accumulation, its optical effect, and cleaning schedules. That literature is extensive, well-quantified and commercially applied – cleaning robots exist because of it.

Partial shading is the other well-studied loss, with a mature engineering response.

Rainwater infiltration is studied mainly as a reliability and degradation issue in accelerated indoor testing – damp heat cycling, humidity freeze – rather than as a field power loss measured over a year of real exposure. Connecting the two, by measuring daily power loss on panels that have accumulated real infiltration in the field, is where this paper contributes.

What it means

For desert solar operators, the practical question is whether their panels have water in them, and most will not know. Infiltration is not visible from the ground and does not show up in a short performance test. It accumulates.

That suggests a monitoring gap. A plant that tracks output per string will see degradation; it will not necessarily attribute it correctly, and the remedy for infiltration is different from the remedy for soiling.

For panel manufacturers and installers, the finding points at sealing quality and frame drainage in arid climates – a design and installation question rather than an operations one.

The bird droppings figure at 20.53 percent is also higher than it sounds, because droppings create hard shading on a small area, which for a series-connected string can cost far more than the shaded fraction.

The honest limitation is scope. These are daily power losses on affected panels at one site. Whether they matter at fleet scale depends on how many panels are affected, and this study does not say.

Business ideas from this paper

Infiltration detection services. Electroluminescence imaging and thermography can find moisture ingress. Offering that as a diagnostic for desert plants addresses a loss nobody is currently attributing correctly.

Sealing and drainage for arid installations. If infiltration is this costly, panel framing and mounting designed for infrequent heavy rain in desert conditions is a product specification worth selling against.

Bird deterrence for solar farms. 20.53 percent daily loss from droppings is enough to justify deterrence measures that solar operators currently treat as optional.

Loss attribution analytics. Plants see output decline and attribute it to soiling by default. Software that separates soiling from shading from infiltration, using production patterns, would change maintenance scheduling.

What could be wrong with it

A small number of panels at one site in one region of Algeria. The paper does not report how many panels or how many measurement days.

The three factors were studied separately rather than in the combinations they occur in. A real installation has dust, shade, droppings and possibly infiltration at once, and the interaction is unmeasured.

Daily power loss percentages depend heavily on the day chosen and on irradiance conditions, and the paper does not report the distribution.

No cost figures and no mitigation trial. The authors frame the work as providing insights for others to propose solutions.

There is no indication of how prevalent rainwater infiltration is across installed fleets, which is what determines whether a 63.5 percent loss on an affected panel is a major problem or a rare one.

Data are available from a co-author on request.

How sure can you be?

We score this 7 out of 10.

It is a peer-reviewed paper in Scientific Reports, based on outdoor field measurements under real arid conditions over a long accumulation period, with named institutions at the University of Ouargla and ENS of Ouargla.

It loses points because the data are not openly deposited, there is no independent replication, and the measurement base is small and described only in general terms.

The methodological choice – measuring factors that take a year to form – is what gives this paper value. Short studies cannot find what it found.

Do this today

If you operate a solar plant in an arid region, commission an electroluminescence or thermographic inspection. Moisture ingress is invisible from the ground and this study suggests it is expensive.

If you are specifying panels for a desert installation, ask about sealing performance under infrequent heavy rainfall, not just damp heat cycling. The field condition in Ouargla is rare rain, not constant humidity.

If you model solar yields, check what loss factors your model includes. Most include soiling and shading. Few include anything that takes a year to accumulate.

Source: Experimental investigation on the effect of real environmental factors on photovoltaic module power output in Southern Algeria, Scientific Reports, June 2026. PMID 41986432 · doi.org ().

Just Out Tech explains new research in plain language. This article was drafted with AI assistance and checked by a human against the original source.

What to remember
  • Rainwater infiltration caused 63.5 percent daily power loss - more than double the next factor.
  • The study deliberately covered factors with long formation periods, nearing a year for rainwater and bird droppings.
  • Real partial shading cost 27.6 percent and bird droppings 20.53 percent.
  • Market panels peak at about 22 percent efficiency, so these losses compound on an already small number.
Where this really is

Different outdoor experiments were carried out under arid climatic conditions in Ouargla, southeast Algeria, taking into account factors with formation periods approaching a year.

Questions people ask

What is rainwater infiltration?

Water getting inside the panel laminate, past the sealing, where it degrades the cell and the electrical connections. It accumulates slowly - the authors note a formation period nearing a year.

Why does a desert study rainwater?

Rain is rare in Ouargla and that is the point: the infiltration builds over a long period from infrequent events, which is why short studies miss it entirely.

What is real partial shading?

Shading as it actually occurs in a field installation - from structures, neighbouring panels or terrain - rather than shading simulated by covering part of a panel in a laboratory.

Are these losses additive?

The study measured them separately. In a real installation they would occur together, and the paper does not report their combined effect.

About the author

Mark Alex

Mark Alex is the founder and Managing Director of Real Biz Digital, a technology company operating out of Nairobi since 2018. He works in agentic AI and the Model Context Protocol, AI governance, enterprise software architecture and cybersecurity. He holds an MSc in Mechatronical Engineering from Obuda University in Budapest and a BSc in IT, Forensic Technology and Cybercrime, from USIU-Africa in Nairobi, and has published IEEE conference research on an AI-powered digital twin for greenhouse systems. He is the author of seven books. Between 2020 and 2024 he mentored more than 200 university students and interns in Nairobi. He writes every Just Out Tech article from the original research paper.